ORION® Gas EndpointsIntegral Endpoint for Sensus® 415 Gas Meters (2 FT3 Index with 18-Tooth Drive Gear Only)ORI-UM-00903-EN-03 (July 2014)Installation
ORION® Gas Endpoints, Integral Endpoint for Sensus® 415 Gas MetersPROGRAM THE ENDPOINT AND INDEXBadger Meter uses a handheld programmer/data collector
Installation ManualINSERT TAMPER PLUGSAfter programming the endpoint is complete and for security purposes, insert the four (4) red tamper plugs (supp
www.badgermeter.comMAKING WATER VISIBLE and ORION are registered trademarks of Badger Meter, Inc. Other trademarks appearing in this document are the
ORION® Gas Endpoints, Integral Endpoint for Sensus® 415 Gas MetersCONTENTSDisclaimer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation ManualDISCLAIMERThe user/purchaser is expected to read and understand the information provided in this manual, follow any listed safety p
ORION® Gas Endpoints, Integral Endpoint for Sensus® 415 Gas MetersLICENSE REQUIREMENTSThis device complies with Part 15 of FCC Rules. Operation of thi
Installation ManualREMOVE OLD INDEX1. Use a large screwdriver to puncture and remove tamper plugs if they are present.2. Use a large screwdriver to
ORION® Gas Endpoints, Integral Endpoint for Sensus® 415 Gas MetersASSEMBLE THE ORION ENDPOINT AND SENSUS 415 INDEXORION Installation Kit for Sensus 41
Installation ManualPLACE THE ENDPOINT ONTO THE METER1. Place the endpoint gasket on the rear of the endpoint. a. Place the two slots through the gui
ORION® Gas Endpoints, Integral Endpoint for Sensus® 415 Gas MetersPLACE THE INDEX ON THE ENDPOINT1. Place two (2) screws (#6 X ¾") into the inde
Installation ManualPLACE THE LENS GASKET AND LENS ON THE ENDPOINT1. Place the lens (outer cover) gasket on the endpoint. a. Place the gasket so that
Comments to this Manuals